discharge of pump
英 [dɪsˈtʃɑːdʒ ɒv pʌmp]
美 [dɪsˈtʃɑːrdʒ əv pʌmp]
水泵出水量；水泵流量
双语例句
- Relationship between discharge and head, power, efficiency of axial waterjet pump with guide vane is analyzed.
分析了不同流量下加导叶轴流泵器的流量和扬程、功率和效率的关系； - The check calculation and tests for the water supply system showed that its main reason is large in the resistance of pipelines and low in the discharge and pressure of pump.
通过对供水系统的校核计算和测试表明，主要是管网阻力大，水泵流量和压力偏小所致。 - Study on Effects of Cold Discharge of Lake Water Source Heat Pump Systems on Lake Water Quality
湖水源热泵系统冷排水对湖泊水质的影响试验研究杓式冷凝水排出装置 - In order to reduce the fluctuation of pressure and discharge capacity of the triplex drilling pump, the air accumulator is often fixed on the discharge pipe.
为了降低三缸单作用钻井泵的压力和排量波动，通常在排出管线上安装有空气包。 - Equally effective in checking back flows from head pressure on the discharge or suction sides of pump.
无论是泵的排泄口的排出压力，还是泵的吸入口，其流体止回的效果都是相同的。 - Discharge of the contents of the tank is effected by a pump.
储箱中装的东西是用泵排出的。 - On the discharge of each pump, compressor, and blower, inside the first block valve or check valve.
卸下泵、压缩机和风机时的首个隔断阀或止回阀内。 - Application of characters of discharge pressure fluctuation to monitor of centrifugal pump
出口压力波动特性在离心泵汽蚀监测中的应用 - By means of controller realized the stepless speed regulation of motor, matched the discharge capacity of pump according to the supply from the well.
通过变频器无级调节电机的转速，使潜油电泵的排量与油井供液相匹配。 - The efficiency, power losses and discharge coefficient of sucker rod pump
抽油泵效率和功率损失及排量系数的计算 - Optimum hydraulic design for discharge passage of large pump
大型水泵出水流道优化水力设计 - The pressure pulse in the discharge pipe of a triplex pump is usually caused by flow rate pulse.
三缸单作用往复泵排出管内的压力脉动是由流量脉动引起的，为减少压力脉动，通常在排出管路上安装空气包。 - After polymer is produced from oil wells the discharge capacity of the electric pump is large;
油井见聚合物后，电泵排量大； - Low recycle volume of purified water after stripping, fresh water for washing floor and direct discharge of cooling water of pump to result in waste of fresh water.
汽提后的净化水回用量小；新鲜水冲洗地面及作为机泵冷却水直排，导致新鲜水的浪费。 - Analysis of flow deviation in two-channel discharge passage of a large pump station
大型泵站双孔出水流道偏流分析 - The differential equation of pump station start-up transient is established and derived from discharge balance and moment equation of pump unit.
本文从水量平衡及水泵机组力矩方程出发，建立起水泵从起动到同步的微分方程式。 - Discharge port pressure calculation of surface-driven single progressive cavity pump
地面驱动单螺杆泵排出口压力计算 - The flow condition and the extracting discharge of the vacuum pump during the process of siphon;
虹吸形成过程中驼峰水流情况及真空泵抽气流量； - Therefore the water injection pump must be modified for pressure upgrading. The method is lessening the diameter of the pump plunger to raise the discharge pressure of the pump.
注水泵压力升级改造是在泵行程和泵速不变，不更换电动机的前提下，通过减小泵的柱塞直径，即减小泵的流量来提高泵的排出压力，以满足注水需求。 - Determination of Maximum and Minimum Discharge of Slush Pump and Operation Parameters
泥泵最大最小流量及运转参数的确定 - Paying attention to high gravitational difference between the suction and discharge of pump while the outlet pressure is lower;
对输油泵吸入端与排出端存在较大位差而泵出口压力较小时的情况不能忽略； - The addendum coefficient is an important parameter in the designing the gear, and to affect the discharge characteristic of compound gear pump.
齿顶高系数是设计齿轮时的重要几何参数，也是影响复合齿轮泵流量特性的重要参数之一。 - Using CP for Automatic Control of Distillation Furnace Discharge Design of submersible pump in use for ore discharge in mine
选用CP（微机）对蒸馏炉排矿辊自动排矿的控制矿用排沙潜水泵设计 - Optimization of suction and discharge plenum chambers of reciprocation compressors in heat pump systems the calculation of average relative pressure losses of suction and discharge of piston type refrigeration compressor
热泵压缩机进、排气腔容积的优化研究活塞式制冷压缩机吸排气平均相对压力损失计算 - Through taking pump station's maximum system efficiency as the object function and the number of pumps as optimization variable, and considering variation in discharge constraint condition, the optimization model for selection of pump type was proposed in this paper.
以泵站系统效率最高为目标函数，以水泵台数为优化变量，以流量变化为约束条件，建立了水泵优化选型模型。 - The cycle performance and discharge pressure of air source heat pump water heater were investigated by changing outdoor ambient temperature, inlet water temperature and outlet water temperature respectively.
通过改变室外环境温度、进水温度和出水温度来研究TJR01在空气源热泵热水器上的循环性能和排气压力。 - Results indicate that flow deviation in discharge passage is formed by co-action of pump outflow circulation and secondary flows in outflow curved pipe, hydraulic loss of discharge passage increases and pump assembly efficiency decreases because of flow deviation.
结果表明：水泵出流环量和出水弯管二次流共同作用形成了出水流道偏流，偏流使出水流道水力损失增大，泵装置效率下降。 - Shaft makes the center wheel spin, drive the rotation and revolution of the planetary gear. It results in the sealing space volume changes, results in suction and discharge of liquid. It is pump function.
转轴使中心轮转动，并带动行星齿轮自转与公转，导致密封空间容积变化，产生吸液与排液，实现泵的功能。